Blog

Bad DVD drive board. Changing the board will be less costly, but will need soldering.

Bad DVD drive board. Changing the board will be less costly, but will need soldering.

If every one of the connections to your DVD drive are protected, it is feasible that the board in the DVD drive has a quick inside it or even a hot scandinavian girls blown surface-mount fuse. Eliminate the DVD drive and change it by having an one that is new see if that really works. If it can, you are able to either replace the whole drive, or look for an upgraded board.

Bad motherboard

Then it may be a bad motherboard if the cables and the drive are not the problem that cause the DVD drive not to turn on. It is hard to try this without receiving a motherboard that is new testing your DVD drive for a known working console. In the event that drive nevertheless works on another board, you will need to change the motherboard.

DVD drive will perhaps perhaps not read discs. The drive takes discs, but doesn’t read them

Bad information cable

In the event that disc is rotating within the DVD drive, nevertheless the system can not read it, then there might be a negative reference to the info cable. The cable is really a ZIF ribbon cable that goes through the DVD drive into the mom board. First, eliminate the DVD drive to there check the connection. If it is fine, you will need to access the text in the motherboard to be sure additionally it is safe. At this time, if the connections are fine, you can also would like to try an alternative information cable, though it isn’t most likely that the cable could be the issue unless there was damage that is obvious it.

Bad laser lens

Then there is likely a problem with the laser lens in the DVD drive if the Wii takes discs, but cannot read them. It is easier and more reliable to replace the DVD drive though it is possible to just replace the laser.

Thermal problems

This can cause disk read errors if your Wii is very warm to the touch. Then completely shut down the Wii (red LED) and allow it to cool down, and then try again if this is the case.

Wii remote isn’t acquiesced by system. Wii remote has lost its sync

Wii console and remote aren’t linked

You are able your Wii remote has “lost” its sync. You can easily clear all past synced Wii remotes along with your console and reconnect the people you will be utilizing. Energy from the system and unplug the energy cable for a couple of seconds. Plug the cord back and turn the Wii straight straight back on. During the “Health and Safety” display display screen, start the door that is small the faceplate associated with system. Keep the sync that is red for at the least 15 moments. All past syncs have actually been taken out of your system at this time. This method doesn’t need become duplicated to re-sync each remote.

Take the Wii that is first remote wish to sync and remove the doorway towards the battery pack compartment. Press and launch the red sync switch close to the batteries. Quickly press and launch the sync that is red regarding the system. The lights in the remote will flash then illuminate the light that corresponds compared to that remote’s position (1, 2, 3, or 4). Continue this procedure for every single Wii remote in just about any desired purchase.

Wii is building a noise that is loud up on. Eliminate the fan to completely clean it or change it having a brand new one.

Bad fan

The fan may become clogged or eventually fail, causing the console to overheat, which could lead to much more serious damage to the device as the console ages.

Bad drive

The drive might be failing if the noise only happens when there is a disc inserted in the drive.

You, you will need to replace the DVD drive if it bothers.

Nintendo troubleshooting

In the event that presssing dilemmas you might be experiencing aren’t covered above, see Nintendo’s Wii Troubleshooting web Page in addition to HackMii Troubleshooting Guide.

Leave a Reply

Your email address will not be published. Required fields are marked *